pfSense 2.4.3-Release (factory image) - PHP 5.6 removed after single package (aws-wizard) upgrade
-
@rico OK - so perhaps a stupid question but when I go to the firmware images link I see two files for the 2.4.4 release - one has an 'ADI' within the name - one does not. Which one should I be using for a SG-4860?
-
ADI
https://portal.pfsense.org/firmware/memstick/pfSense-netgate-memstick-ADI-2.4.4-RELEASE-amd64.img.gz
Thank you.
-
Thanks for the replies - used the image to install 2.4.4 and then restored my config - that went just fine - only issue is that the menu item for the old autoconfig backup remains - which confused me at first until I read about where the new one is located under the services menu.
-
The ACB menu entry left under Diagnostics is a known issue, we'll come up with a fix for that in 2.4.4-p1: https://redmine.pfsense.org/issues/8959
-
@jimp Great - thanks for the response.
-
@rico Yeah, but it causing lots of problems for many users, what is your solution then?
-
Then just jump back to 2.4.3-p1 and wait for 2.4.4-p1 ;-)
-Rico
-
@rico 2.4.3 p1 is no available.
Only option is the 2.4.3 image I had.
Did 2.4.3 p1 come as an isntaller image? I thought the patches were applied as an update? -
Yes there are 2.4.3-p1 Images around, pfSense-netgate-memstick-2.4.3-RELEASE-p1-amd64.img.gz for example.
-Rico
-
@rico said in pfSense 2.4.3-Release (factory image) - PHP 5.6 removed after single package (aws-wizard) upgrade:
pfSense-netgate-memstick-2.4.3-RELEASE-p1-amd64.img.gz
Do you have that image, it's pulled from the web.
If somone has this image, pls share a link, either here or by private message -
The -p1 images are only for Netgate hardware, not installations using the community edition. There were no -p1 installers for CE.
