Multi-WAN Port Forward Blocked (Showing Incorrect Interface in logs)
-
Looks like your ISP is sending you traffic for 174.X.X.214 on WAN2 when it's up.
Why is that?
All of the blocks shown for WAN1 look like ports that have not been forwarded/passed and should be blocked.
Should probably also show your switch configuration just to be sure that's all correct.
-
WAN2 was historically connected to a different router and served guest wireless on a completely separate physical network. In that configuration, we didn't see these issues.
Also, when WAN2 is enabled, it doesn't block all traffic incoming to the 214 IP. Seems random. For instance, one of my cell phones connected fine, but the other one was blocked and stated WAN2 for the interface. Maybe this is something to do with active states before enabling WAN2, but I also cleared all states after enabling the interface and still had working devices.
WAN2 is also on a completely different IP range. It seems like the rerouting of traffic is happening within the Netgate router, just not sure what is causing it. Attached are the switch configuration pages.
-
Traffic to that address should never be arriving on WAN2. That's the point.
Is it the same ISP? Same subnet or something?
-
That's why I'm confused. Same ISP. Both enter through the same ONT, but are on completely different ip ranges. See screenshot below of WAN2 IP.
-
Like I said, you need to get with them to see why they are sending that traffic to the wrong WAN. Are you sure it's supposed to be two connections and not one with a routed subnet? Two WANs from one provider over one fiber doesn't make any sense to me from a redundancy point-of-view.
-
Thank you for the reponses. I will get with the ISP and see if they can find any errors on their end.
While these do eventually terminate to the same ONT, they are two different services. Because we are in the middle of nowhere, we somehow ended up with their junction box, that would typically go outside, inside our server room. They serve our phones and internet from there. I am told these two services actually originate from different directions to our building. They are also billed as two completely different services as well. -
OK
From what you have posted it looks like the traffic for that destination address is really arriving on ETH3. Not a lot the firewall can do about that.
-
I agree, just wanted to be sure there wasn't some goofy setting that would somehow re-route the traffic before it hit the firewall service and make it look like it originated from ETH3.
-
Looks like you may be onto something here. Performed a tracert using WAN1 to 8.8.8.8 and the first hop is using an IP in the same range as the WAN2 address. Both WAN1 and WAN2 use the same first hop. Very interesting. Will definitely be speaking with the ISP about this.
-
You never know what IP address will respond to a traceroute. It could be sourced from any IP address on the router.
What matters is what interface traffic destined for your IP address arrives on.
