Limiting Guest VLAN only
-
Hi,
Maybe this has been answered elsewhere but I can't quite find the answer I'm looking for.
I have a guest VLAN setup, and want to limit the bandwidth at all times to 2Mbit/s.
So far, I've gone to Firewall > Traffic Shaping, clicked on the guest VLAN under the "By Interface" tab, clicked enable, and set the bandwidth rate.
However, the GUI then has a Queue Limit option (I just put 20; no idea if that's right), and a button underneath marked Add Queue that brings up a whole raft of options I simply do not understand.
Are these basic steps enough to apply a generic bandwidth limit, or do I actually need to configure the Queue screen?
Regards,
Rob. -
Use a limiter, not a shaping queue.
https://doc.pfsense.org/index.php/Limiters
-
Ahh, thanks, I had been under the impression Limiters applied globally, but I missed the In/Out options when I was looking at it.
Regards,
Rob.
