IPMI not working

theaddies · Apr 22, 2015, 9:18 PM

I am using a Supermicro A1SAM-2550F for my PFsense machine. I was looking to connect up the dedicated IPMI ethernet connector and have had some issues. The bios says "IPMI Firmware Revision-not working". I know this isn't a pfsense issue but I know lots of folks on here use these boards, as do it. Do I need to configure a dip switch somewhere? I cannot figure out what needs doing. Thanks in advance.

Wolf666 · Apr 24, 2015, 12:04 PM

Are you able to see your MB from IPMIView application? You can also reach the Webgui from any browser, you must know the assigned IP to IPMI interface. I have a A1SRi-2558, IPMI works pretty fine.
Try to get the most updated firmware and bios.

http://www.supermicro.com/solutions/IPMI.cfm

http://www.supermicro.com/support/bios/firmware0.aspx