Setting up Minimserver
-
Hi,
Maybe it has been covered before... In that case sorry for asking again :)
Might be that this is not in the correct sub-forum, but did not know where to place it otherwise.I wanted to implement the following (on Intel i350-T4) :
NIC1 : 192.168.1.x : LAN (PCs, Printers etc.)
NIC2 : 192.168.2.x : NAS (Data and Multimedia on seperate NAS)
NIC3 : 192.168.3.x : MEDIA (Several audio renderers, Smart TVs etc)
NIC4 : 192.168.4.x : Wireless StuffI am running Minimserver on my NAS, so on NIC2.
I need to have my control points on both NIC1 and on NIC4.
Audio rendering is done on devices attached to NIC1, NIC3 and NIC4.But it seems that : "MinimServer expects the control point and renderer to be on the same subnet as the device running MinimServer. I don't know of any way to do what you want." (as quoted by SImonCN, minimserver author).
Is there anyway I can implement / resolve this in PFSense?
Since I am still learning PFSense, a good explanation on how to would be highly appreciated.
Regards.
-
@Patpop said in Setting up Minimserver:
MinimServer expects the control point and renderer to be on the same subnet as the device running MinimServer
And how/why is that - how does it discover these other boxes? A broadcast, multicast - what protocol does it use to discover.. Or do you enter their IPs?
Put them on the same vlan if that is what is required.
-
Appears to be UPnP AV. So all multicast discovery shenanigans.
