SG-1100 WAN port DOA?
-
Looks like mine probably isn't bad - there was some issue with the switch. Trying with another switch seemed to work (even though the initial switch worked with the LAN and OPT ports, as well as other devices plugged into it... very weird). Maybe there's some peculiarity there or something, but I'm going to treat it as a switch issue for now and see how far that takes me.
-
Hmm, odd. As far as I know the three ports are indentical by default.
Let us know if you see any other weirdness.
Steve
-
I brought mine into work to try it and it took a while but the want port did come to life and got an IP. I have just a ethernet cable direct from my Fios ONT and it works fine on the SG-1000 but hours of messing around last night it would not come up on the SG-1100. Getting ready to take it back home now and try it again.
-
If you can try an unmanaged switch in between the SG-1100 and ONT if it's still not linking.
Steve
-
@carter69 when I setup my SG-1100 I had connected my laptop directly to Fios ONT via Cat5 to test the connection after switching from Coax to Cat5. I had to wait for the DHCP lease to expire before I could pull a WAN address with the SG-1100.
-
I got it to work when I was at work, so factory reset it and took it home, and it took a while before the wan connection would show as active to get past the prompt of which port is wan or Auto detect. It did finally come up. I let it run for a bit then restored my old config and the gui asked to assign the wan, lan and opt, and I did, and restart and it starts back up asking for the WAN adapter and just lists mvneta0 and a for auto. It would never get past it saying the link was not up. So factory reset again and gave up on restoring the configuration from the SG-1000 and configured it by hand.
I then lost the WAN a few times in a few hours , but I was also seeing that with the SG-1000, so back to running the Frontier router to wait for it to die again so I can call them and have them check my connection. Much easier to talk with them when you just give up and plug their hardware back in :)
-
I was having a similar issue. The WAN port would come online but would drop or go offline/down within a few hours to days. Worked with support and they RMA'd the device. Got the new device in and set the static IP on the WAN and the WAN will not come up. Waited for several hours and got tired of hearing the wife and kids complain about no internet. I then put a 5 port netgear switch in between the WAN and the fiber modem (ISP provided) and the WAN came up. Working with ISP now to see if they need to change anything but if you guys have any further insight please let me know.
-
That usually implies a negotiation failure between the devices. Does the switch show both devices connected to it at 1Gbps?
Steve
-
@stephenw10 no the sg-1100 side 1Gbps and the ISP side is 100Mbps.
-
Ah, well the ISP device might be set at a fixed 100Mb instead of auto negotiate in which case negotiation will fail.
You can try setting the the switch port to 100Mb full duplex on the SG-1100 to match that.
Steve
