Enable DHCP only on LAN IN
-
@johnpoz Can't figure out how.. I created a vlan and assigned it as another interface but couldn't select it in dhcp server config though it has a static local ipv4.
-
did you enable dhcp server on it?
Any interface is NOT a wan, ie doesn't have a gateway set and has a static IP on it be native or vlan will be listed as being able to have dhcpd enabled or not.
Two of those W_ interfaces are vlans.
Did you actually "enable" the interface ;)
-
@johnpoz Doesn't work for me:
--------------------------------------------------------------------------------------------------------------
Guess I missed a configuration but this is looking pretty similar to yours.
.
.
.Well, I guessed I messed up something anyways, can't connect to firewall services through VPN anymore (is dhcp required for this?).
-
If I manually type the iface name in the url it's working. Maybe this is just a bug in dev branche version?
-
And your opt1 interface is actually "enabled" you can put an IP on it without actually clicking "enable" show us your opt1 interface.
Your running 2.5 ver - then you post should be in that section
-
-
Well I can tell you the mask is wrong.. You can not run dhcpd when the mask is /32 there is no range to use - you prob want that at /24
-
@johnpoz Indeed, that was the trick. Thank you so much, I didn't notice that it was set wrong.
Now I can block traffic to WAN and stop it going out of the network.
-
Not really a "trick" but yeah setting /32 for sure not going to allow you to run dhcpd ;)
-
@johnpoz Yh no magic.
This would block dhcp traffic from going out and keep it inside that vlan? Sry for that dumb question, used to have different nic's before for this, haven't really worked with vlans before.
