Error when checking for coreboot update
-
Good evening,
I just received a new SG-5100 and have it up and running. However, when I check for a coreboot update I get:
The following input errors were detected:
This function is only available for Netgate Inc. hardware
This is a 100% authebtic device. My config has been run on both official and unofficial devices. Perhaps there's something on there causing this? Please advise.
-
https://forum.netgate.com/topic/142102/systemnetgate-coreboot-upgrade
-
Well, that summed it up pretty sweetly. I'll remove the package now and move on. Thanks for the help!
-
Why is the coreboot package installed by default in a sg5100 factory image? Why doesn't netgate remove the coreboot package from the sg5100 factory images if they know that system does not use/support it?
-
I'm not sure that it is??? I imported a config from an SG-2440 which DOES use coreboot. So I assume the package was installed as a result of importing the 2440 config.
-
@ngoehring123 said in Error when checking for coreboot update:
I'm not sure that it is??? I imported a config from an SG-2440 which DOES use coreboot. So I assume the package was installed as a result of importing the 2440 config.
It is. I recently purchased an SG5100 and it was installed. It appears even after reinstalling from the factory image. I guess 5100 uses a generic pfSense image that other devices use that happen to use coreboot and netgate rather not go to the trouble of making a special image with coreboot removed just for the 5100.
-
@gfeiner very interesting and odd. I would have expected the customized image to be 100% configured to the devices capabilites. They really should make a note in the quickstart guide or something.
-
Thanks for pointing that out. I don't think anything using the VGA memstick image needs the Coreboot updater. I'll see baout removing it.
Steve
