Trouble setting up SG-1100 for Google Fiber

[shad0wca7]

I've bought the SG-1100 and it seems like a neat little device.

There's some discussion around that Google Fiber no longer requires VLANs for using your own gear but I didn't get an IP assigned when I plugged in for initial setup.

I've tried to follow some guide to set things up for the SG-1100 and its switch configuration although I'll admit I'm still a little confused with that.

I've even cloned the MAC of the Google Fiber box by assigning the main interface (PHY) and changing the MAC but I'm just not getting assigned a WAN IP address..

Screenshots below:

What's my mistake?

[stephenw10]

You probably want the switch members for VLAN 2 to be 0t,3t assuming Google requires VLAN 2 tagged traffic upstream.

Steve

[shad0wca7]

@stephenw10 thanks I’ll look into that tomorrow when I get back and can adjust it.

Does the sg-1100 need a soft / hard reboot after changing switch parameters?

I had to do a hard reboot when bridging opt and lan to get it working but hadn’t seen that step in the little forum guide on that..

[stephenw10]

No, no reboot required.