iperf3.0 cannot be stopped (with widget /or gui)
-
Hi !
After updating package to iperf3 the widget of welcome page ( services / iperf ) is broken (it's show a status of down and start / stop don't work anymore...) it must need an update i think .
So you can launch iperf3 server but the only way to stop it is a kill command .I use 2.4.4-RELEASE-p3 (amd64)
bye.
-
Should be fixed in 3.0.1, give it a shot when it shows up.
-
Yeah 3.01 is listed, installed and tested
$ iperf3.exe -c sg4860.local.lan warning: Ignoring nonsense TCP MSS 0 Connecting to host sg4860.local.lan, port 5201 [ 5] local 192.168.9.100 port 50684 connected to 192.168.9.253 port 5201 [ ID] Interval Transfer Bitrate [ 5] 0.00-1.00 sec 68.8 MBytes 577 Mbits/sec [ 5] 1.00-2.00 sec 71.6 MBytes 601 Mbits/sec [ 5] 2.00-3.00 sec 73.6 MBytes 618 Mbits/sec [ 5] 3.00-4.00 sec 73.0 MBytes 612 Mbits/sec [ 5] 4.00-5.00 sec 72.2 MBytes 606 Mbits/sec [ 5] 5.00-6.00 sec 72.0 MBytes 604 Mbits/sec [ 5] 6.00-7.00 sec 73.0 MBytes 612 Mbits/sec [ 5] 7.00-8.00 sec 73.0 MBytes 612 Mbits/sec [ 5] 8.00-9.00 sec 73.8 MBytes 619 Mbits/sec [ 5] 9.00-10.00 sec 73.4 MBytes 616 Mbits/sec - - - - - - - - - - - - - - - - - - - - - - - - - [ ID] Interval Transfer Bitrate [ 5] 0.00-10.00 sec 724 MBytes 608 Mbits/sec sender [ 5] 0.00-10.01 sec 724 MBytes 607 Mbits/sec receiver
But it doesn't stop the server when you go back to iperf server page, it still running.. Where would the stop button be?
[2.4.4-RELEASE][admin@sg4860.local.lan]/root: ps -ax | grep iperf3 41418 - I 0:21.94 /usr/local/bin/iperf3 -s
Also 3.7 has been out for quite some time (6-21-19), I take it they have not updated the freebsd packages yet?
-
It should be in Status > Services or the services widget
-
Ah, no way to put it say in the actual iperf page? That would be more intuitive I think.
Yeah its there, and that works.
-
No the way it's coded now since it's just an XML package not a PHP page that could do that easier. If you start it again with new settings it does kill the old session, though, so it's not like you'd keep running more and more copies.
-
whaoo that a quick fix. thanks !
-
I added shortcuts to iperf as well for the next release, so it will have a little service control button in the navigation bar. That should help, too. I found that XML-based packages like iperf were not actually able to setup shortcuts, so there was a bug I had to fix for that to work.
It will be in snapshots soon. That can't work for 2.4.4-p3 though, since it requires a fix in the base system.