[SOLVED] OpenVPN for Guest Interface
-
It's not overly clear what you're saying, is it:-
-
OVPN client access into your router and restrict where they can go, if you want this its firewall rules.
-
OVPN connection to Nord or Tunnelbear, etc ..., restrict access and you just want to policy route traffic from the guest interface out to Nord, Tunnelbear, etc ..., then firewall rules, then policy based routing you'd need to set the Gateway.
-
-
What do I select in destination, can't find openvpn in there.
-
Still don't have a clue on what you exactly want.
Also why would you put a rule on the LAN interface rather than the OpenVPN interface if you want to block what the OpenVPN net has access to.
-
Oh, I have OpenVPN Client setup on PfSense, But I only to apply that openvpn client to apply my guest interface only, Instead of being applied to the entire network. I dont want to have vpn on my LAN, just on Guest.
-
So you want the Guest network to route out over the OpenVPN connection?
-
Yes, Only guest Network.
-
You just need to change the gateway on the outbound traffic.
Look at policy based routing, outbound NAT & also look at VPN killswitch.
-
What is destination, ipv4_local
-
Thats my local subnets, basically block everything to my local subnets then allow anything that isn't my local subnets and set the gateway to use NordVPN.
-
ok got it, let me try
-
Can't find gateway option,
-
Need to edit the pass rule on your guest interface that passes the traffic and look in the advanced section.
-
Sorry, I am confused, this how the setting are,
-
-
Thanks
