WAN interface changed speed from 1000 base to 100 on it's own.
-
Hello my WAN interface changed speed from 1000 base to 100 base on its own over night dragging down my internet speeds today. Any reason why it did this? I do see it can be set static but it said its advised not to. If I can, which option should I use? Thanks
-
Have you tried another Cable?
-Rico
-
No, It's a pre molded cable and never had an issue on my old setup before I deployed this.. It's just odd it did this. It could be bad but easy enough to check.
Update: Cable seems fine. switched it out anyway. But could there be any way it did it if the cable is good. the cable checks out fine on my RJ45 tester.
-
Huge interference in the area? Port failing (at either end)? Realtek NICs living up to their reputation? All three....
What are you connecting the WAN port to?
Steve
-
@hilltop79 said in WAN interface changed speed from 1000 base to 100 on it's own.:
No, It's a pre molded cable and never had an issue on my old setup before I deployed this.
A change from 1 Gb to 100 Mb usually indicates a bad cable. Even pre-molded cables can fail. It's easy enough to try a new one.
-
I noticed that also on LAN, although it happened once for me on Feb 10, 2020...I am on pfSense 2.5-dev.
-
Maybe It could be a network crash. I do remember plugging a live port back into the switch on the LAN side accidentally while testing last night. But that was the LAN side not the wan. Maybe it did soemthing.
-
Why don't you just try another cable? Cables are a very common cause of problems. If there are any broken wires in the cable, the connection may autonegotiate at 100 Mb, but not 1 Gb.
-
There could be a all kinds of reason for this to happen... But yes as mentioned cable could be an issue.. connection could be a problem.. Try resetting the connection - plug the cable in again..
-
@JKnott I did, see past reply's. I will not know till and if it happens again.