VDSL 2 PCIE Card wan configuration Help
-
Does anyone know how to configure a Draytek Vigor 132F with pfsense to work in bridged mode and then diagnose the pppoe settings with any sort of diagnostic commands?
-
If it's anything like their other devices it will be in bridge mode by default. You would just configure the interface it presents as WAN and setup PPPoE on it.
The Fibre failover part could be more complex...Steve
-
@Studmuffin1134 said in VDSL 2 PCIE Card wan configuration Help:
Draytek Vigor 132F
Didn't someone post ages ago how to get it to work, it was the ethernet version, I think it just occupied a PCIE slot for power.
https://forum.netgate.com/topic/106404/a-day-with-the-vigornic
https://www.draytek.com.tw/ftp/VigorNIC%20132/Document/draytek_VigorNIC%20132%20datasheet-160829.pdf
Probably best to find a copper SFP for it.
-
Hmm, the addition if the bridge makes no sense there at all IMO. I would certainly not do that, you should be able to just route between the two subnets of you need access to the modem.