CODELQ - DUAL WAN FAILOVER - 2.4.5-p1
-
Hello,
Running 2.4.5-p1 with one connection SMB Cable, and the other SMB DSL CODELQ works just fine when on the Tier 1 Connection (SMB Cable).
I followed these instructions: https://www.youtube.com/watch?v=o8nL81DzTlU
Recently I had a backup connection installed, just Verizon DSL, and I setup a traffic shaper for it. I created copies of existing queues from the WAN and adjusted the bandwidths.
Today when primary connection failed, backup did not work. It worked when I disabled the floating rule for that interface. I may have even setup, and tested, the QoS rule before I upgraded to 2.4.5-p1 but I cannot remember.
I seen this for 2.5.0: https://redmine.pfsense.org/issues/9643
I have triple checked the settings. The next thing I was going to do was setup a test machine, and add a firewall rule to have it use the backup as primary internet so see if it works QoS enabled then.
At first I thought everything was fine, because pings were going through the backup connection. I thought that I put the wrong speeds in. I checked and they are good.
I saw someone post an issue about using low Kbit speeds, in this same forum. DSL upload here is like 700kbits.
I thought I tested this to work though.
Anyone have any ideas?
-
Not an emergency, but a real issue, no one has experienced this?