How to find/copy bnxt (Broadcom BCM57412 NetXtreme-E 10Gb) drivers from pfSense 2.5
-
I have a Dell PowerEdge server R640 with two 10gb ports and two 1gb ports. I have installed pfSense 2.4.4 but the 10gb interface wont show up. I have installed pfSense 2.5.0-Development and the two 10gb interfaces show up. Is there a way to copy the drivers on to the /boot/kernel of pfSense 2.4.4?
-
Not from 2.5. The drivers are all in-kernel and not modules in pfSense so you cannot copy them out. But even if you use FreeBSD 12-stable the modules would not load into the pfSense 2.4.X kernel. You would have to compile the driver that includes support for your NIC against FreeBSD 11-stable and then use that resulting module. That might involve significant coding to back-port it though.
Steve
-
Thanks. Sounds a bit too complicated for me.
-
Is this setup for some sort of enterprise production setup? If not you prob ok with just running 2.5, it is getting close to release I would think.. That could still be a good time off - but I am not aware of any roadblocks to using it.
Just make sure you take good backups before updating to the latest snap, etc. In case a snap breaks something you can always roll back.
-
It actually looks like that card should already be supported in 2.4.5. The driver is there.
Move to the other thread: https://forum.netgate.com/topic/158861/nic-broadcom-57412-10gb-not-recognized-on-pfsense-2-4-5
Steve