PFSense [RST, ACK] packet when accessing a site
-
@johnpoz thanks to you and steve for the clarification. freenas is freebsd.
how can i establish what on the box is causing it?
e.g. ip tables, etc?can you offer some commands i could use to validate pls
-
No what stephenw10 is talking about is a source nat to get around rules that might stop traffic to a device, where the traffic is from another network.
server is on vlanX 192.168.1.100 for example, and you want to talk to it from device on vlanY 192.168.2.200 for example.
If 1.100 does not allow access to its services, because of firewall, or lack of gateway for example. You can do a outbound, or source nat to trick the 1.100 device to think the traffic came from pfsense IP in vlanX, say 192.168.1.1
This is outbound nat, set on the vlanX interface to set the source of the traffic to pfsense IP address in that interface. Here is example I have setup to talk to 9.101 device on my network because it has no gateway. So to the device when I talk to it from my vpn... It thinks the traffic came from pfsense IP address 9.253
I would not suggest this, unless the reason you can not talk to the device is no gateway.. You need to adjust the firewall on the device your trying to talk to allow traffic from where your talking from.
-
Yes, that ^.
But, also yes, you can use that to prove where the problem is but you should fix it at the root which is probably the server config or some rule in the FreeNAS networking.
Steve
-
@stephenw10 ok, guys. thanks. I can see the port 8000 is coming from the svr vlan gateway address now instead of the wh2900c. and it is still being reset.
So it is clear, it is the truenas 12.1 box (or the jail that the weewx is running in).
any chance to guide me here with your freebsd knowledge pls
-
How exactly are you seeing that? In the state table? Packet capture?
I would have expected the connection to succeed after being translated to the interface address.
Steve
-
@stephenw10 packet capture instead of the wh2900c address from before, it shows the svr vlan gateway address. so both addresses are on the same network.
-
Mmm, OK. Well if you are seeing traffic leave the interface the server is on and using the interface IP then pfSense is both routing and translating correctly.
Something in the FreeNAS firewall or the server config is rejecting it for some other reason.Check the server logs. Are those requests actually getting that far?
Steve
-
@stephenw10 thanks guys. i got it working. was an issue with the application.
-
@gwaitsi said in PFSense [RST, ACK] packet when accessing a site:
i got it working. was an issue with the application.
I would remove your source nat then.. I wouldn't recommend natting between local networks.
-
@johnpoz already did, thanks :-)
