Cannot access my router after pfSense installation. Please help a newby
-
Reboot your cable modem. Your pfsense router should get a new IP on the WAN side. It'll still be 192.168.1.1 on the LAN side.
-
This post is deleted! -
@nguser6947 It worked after I rebooted the router and then after a few minutes, I can't access my router again. What else can I try? Thanks in advance
-
@tittu what is your pfsense version?
-
@akegec thanks for your reply. I have the current version.
2.5.0-RELEASE (amd64)
built on Tue Feb 16 08:56:29 EST 2021
FreeBSD 12.2-STABLEThe system is on the latest version.
Version information updated at Fri Apr 2 2:17:52 GMT 2021 -
@tittu Have you tried powering down both the cable modem and your pfsense router, then after 5 minutes power up the cable modem (only). Wait another 5 minutes and then power up the router.
-
@nguser6947 thanks for your reply. I have tried everything I could.
The problem is that my LAN is 192.168.1.x and my WAn is 192.168.0.x. This means that they are on different submets.
How do I allow traffic from the LAN to access the WAN? When I changed my LAN IP address to the WAN ip, I’m able to reach my router to configure it. I was thinking of installing another NIC and have it on the WAN subnet but this is annoying.
Thank you
-
@tittu
On pfSense by default- anything on the LAN interface is allowed
- outgoing traffic on WAN is masqueraded so that your router should see the WAN IP of pfSense, when you access it from a LAN device. So the access is coming from within his own subnet.
Don't know if you did any changes on this.
Has your pfSense as well the public IP on the WAN (PPPoE)?
-
@viragomann thank you for your reply. The only thing I did was added a paid VPN service on another port. It’s called Surfshark VPN. All the other settings are normal.
-
@tittu
So there is no public IP on the WAN, only 192.168.0.3?Are you able to access the router, when the vpn is down?
-
@viragomann yes, I can access the router when I shutdown and restart the router or pfsense box
-
Just watch fellowship of the bitches this week it's so funny... Anyway tried to ping LAN when prob occurs and reset states: Diagnostics > States > Reset States > check reset firewall states table> save