Sharing a Port with OpenVPN and a Web Server
-
-
@johnpoz said in Sharing a Port with OpenVPN and a Web Server:
Your actually making a connection? Can you ping 192.168.1.1, but not say 192.168.1.X a device on your lan?
Correct. I can ping 192.168.1.1 bit nothing else on my LAN e.g. 192.168.1.20
-
@frankzappa
Actually, disregard the previous post. From my LAN, connected to OpenVPN 443, I can now ping everything on LAN (from within LAN). -
@frankzappa
I still can't access the internet, or my local LAN from the WAN using TCP 443. Not sure what I'm doing wrong. -
@frankzappa You have not local network setup, nor are you redirecting all traffic through the vpn.. So no you wouldn't access anything through that tunnel..
You need to set the local network(s) up, or you need to route everything through the tunnel.
How would the remote client know to go down the tunnel to get anywhere?
And why do you have port share setup?? You do not want or need that..
-
@johnpoz
Thanks. Not sure what you mean (or how to) "set the local network(s) up, or you need to route everything through the tunnel" How do I do that? -
@frankzappa
Ok, I think I figured out setting up the local network. I added 192.168.1.0/24 in the window. However, my iPhone (wifi off/connected only to phone data) won't even connect to my OpenVPN server on TCP 443. However, UDP 1194 works fine. Something I'm missing? -
@johnpoz
Thanks again johnpoz. I'm almost there. I can connect from WAN to OpenVPN on TCP 443 and UDP 1194. Two remaining issues:- I can't connect to my local NAS. I can ping it, but can't connect via OpenVPN. Same for everything else on LAN.
- When I run a security scan (Shields Up) It gives me the giant red "FAILED" as it shows port 443 wide open (saying it's unsafe to have this open).
Is there any way to prevent port scanners from showing TCP 443 wide open? It doesn't show UDP 1194 as open (and yet it is).
Thanks
-
The scanner doesn't scan udp that is why its not showing 1194.
No there is no way to have the port closed, but yet people connect ;) Your vpn is pretty freaking secure.. And openvpn will just drop packets that are not vpn packets from your clients.. look into what tls key does.. "correct HMAC signature"
To you nas.. Look to the nas firewall - I highly doubt it allows something other your lan network, ie your tunnel network (vpn client IP) to access its shares, etc.. it might allow ping.
If you can ping it.. Then you have connectivity and issue is pretty much 99.9999 sure is local firewall of the device.. Unless on your openvpn interface rules you limited that to icmp? It defaults to any any..
-
@johnpoz
Thanks Again. I'll play around with NAS firewall to see if that's the issue.
