Trying to add second subnet to LAN



  • I am trying to add a second subnet to my LAN

    First subnet is 10.9.8.X - Router is set as 10.9.8.1, everything so far works as expected
    Now I wanted to add a second subnet as 10.75.5.X

    I have added a virtual IP setup as 10.75.5.1 and can ping that address from any PC on the 10.9.8.X subnet

    I have equipment on this second subnet as example 10.75.5.30 but I cannot ping or see that equipment.

    I have added in the Firewall Rule:

    IPv4 * 10.75.5.0/24 * * * * none and the same for IPv6

    As for the LAN has
    IPv4 * LAN net * * * * none

    and have added an outbound NAT  for that subnet
    WAN  10.75.5.0/24 * * * WAN address * NO

    Not sure what I am missing to be able to access the equipment on the second subnet and for the equipment on the second subnet to be able to access the internet using the primary gateway. Also take note that everything goes onto the same switch.



  • I also just tried:

    System: Advanced: Firewall and NAT, called Static route filtering – Bypass firewall rules for traffic on the same interface.

    Still no go