UPnP & NAT-PMP settings restore



  • Found a bug (I think)..

    If the UPnP & NAT-PMP setting is enabled, a backup and restore to clean install won't restore it's settings. Everything else restores but UPnP & NAT-PMP comes up disabled (unchecked)



  • Can anyone confirm this? OR if this will be fixed with an update?



  • There's nothing special about the upnp config, it restores as it was when the backup was taken.



  • I have done restores on 3 fresh installs with same results. The upnp config is not restored. It was configured before backup and I can see the config xml file has the info.



  • Guessing you cleared out the <installedpackages>section of the config backup before restoring. Though uPNP is in base now, its config is still under <installedpackages>. It restores fine where the settings are correctly in the restored config.</installedpackages></installedpackages>


Log in to reply