I want to setup Site to Site VPN using PF sense and Sonicwall.

  • Hello Everyone

    I need your help in setting up of Site to Site VPN using PF sense and Sonicwall.
    I have one site which uses Sonicwall and another site uses PF sense which I have recently installed.
    I followed all the steps which was mentioned on the article https://doc.pfsense.org/index.php/Routing_internet_traffic_through_a_site-to-site_IPsec_tunnel till IP sec phase 2.
    There is something which I am missing please let me know its important for me Also I would request you to please have a look at these images these images contain the setting which I applied on PF Sense.

    These are the configuration of my PF sense please have a look and let me know if I am missing anything.

  • Looking through your screenshots, I saw an error. Under General Information for the Phase 2 settings.

    You have for the local Network /24

    When it should be /0 to route all traffic from the remote network to the pfsense box.

Log in to reply