MultiWAN Limter Setup



  • Hi,

    I'm currently doing some testing with a PFSense 2.3 installation and have run into an issue with Limiters. My configuration is MultiWAN with dual PPPoE 50/15(WAN1) & 20/7(WAN2) bandwidth configured for fail-over using Gateway Groups. In order to improve user experience I have implemented limiters @ 40/10(WAN1) & 15/5(WAN2). While this works perfectly under normal conditions…when fail-over occurs the limiter remains at 40/10 resulting in a saturated WAN2. Is this a symptom of using gateway groups?

    Any input is appreciated...I'm new to PFSense but so far it has been an extremely positive introduction.

    Cheers,

    D


Log in to reply