Pfsense and Untangle in Bridge mode…unable to connect internet..please help

[Davec]

Need some advise on the following setup, please.

Currently I would like to setup the Pfsense as firewall and Untangle to filter. Both PF and UT are set in Bridge mode. May be my configuration is wrong, I cannot get them to connect to Wan.

If I use PFsense only in bridge mode, Lan can access to internet traffic  :D
If I use Untangle only in bridge mode, Lan can also connect to internet traffic  :D

But once I have Pfsense and Untangle together in the network, I cannot access internet traffic.
The pfsense Internal Nic and Untangle Wan Nic do not seems to have connection. I have already change a number of cables and tried to use cross cable…but still not work.  :-\

Internet
Public IP 218.xxx.xxx.xxx

I (Straight cable)
I

Router
Gateway: 192.168.0.1
Mask: 255.255.255.0

I (Straight cable)
I

Pfense (Bridge Mode)
Wan IP: 192.168.0.2
Gateway: 192.168.0.1
Mask: 255.255.255.0

Lan IP: 192.168.0.3
Gateway: 192.168.0.1
Mask: 255.255.255.0

I (Straight cable)
I

Untangle (Bridge Mode)
Wan IP: 192.168.0.5
Gateway: 192.168.0.1
Mask: 255.255.255.0

Lan IP: 192.168.0.6
Gateway: 192.168.0.1
Mask: 255.255.255.0

I(Straight cable)
I

Lan switch
IP: 192.168.0. 6 - 192.168.0.254
Gateway: 192.168.0.1
Mask: 255.255.255.0

Thanks.

[nocer]

Hello,

But once I have Pfsense and Untangle together in the network, I cannot access internet traffic.
The pfsense Internal Nic and Untangle Wan Nic do not seems to have connection. I have already change a number of cables and tried to use cross cable…but still not work.  :-\

just a curiousity, what happend if you put another switch between pfSense and UT? Does link come up?

–-router---pfSense---(switch)---UT---

Will you check once again auto-nego, or you can force to configure, say 100-full at each side.

While you're struggling to get link works, did you see any messages/logs on both pfSense and UT boxes? pfSense usually gives you a log when you plug/unplug the cable, did you see that? Same thing at UT side, any logs/messages seen?

cheers,

[Davec]

Dear nocer,

You are absolutely right about the forcing the config to 100-full duplex instead of Auto-nego.

I can now access from the Lan to the Internet.

Many Thanks for your advise.

Best Regards,

David

[nocer]

Good for you  ;) ;) ;)