Fallback not working?
-
Simple. Wan1 is a 25mb broadband, wan2 is 6mb dsl. I have a group setup with Wan1Primary. Wan1=Tier1, wan2=tier3. However it appears at some point Wan1 experienced high latency and routing switch to wan2, But when latency went back to acceptable levels, from what I can tell both OpenVPN and xinet remained on wan2. Only when I forced down wan2 did the default route switch. Shouldn't the link have switched back to wan1?
Oct 20 15:17:11 xinetd 15914 Reconfigured: new=0 old=1 dropped=0 (services)
Oct 20 15:17:11 xinetd 15914 readjusting service 6969-udp
Oct 20 15:17:11 xinetd 15914 Swapping defaults <–-- THIS HERE, the default should have been CC25 to begin with??? Oct 20 15:17:11 xinetd 15914 Starting reconfiguration
Oct 20 15:17:10 php-fpm 46394 /rc.dyndns.update: MONITOR: WAN2GW is down, omitting from routing group CC25Primary
Oct 20 15:17:09 php-fpm 49192 /rc.filter_configure_sync: MONITOR: WAN2GW is down, omitting from routing group CC25Primary
Oct 20 15:17:09 php-fpm 49192 /rc.filter_configure_sync: MONITOR: WAN2GW is down, omitting from routing group DSLPrimary
Oct 20 15:17:08 php-fpm 46394 /rc.dyndns.update: MONITOR: WAN2GW is down, omitting from routing group DSLPrimary
-bob -
xinetd is not switching anything to do with WANs. It's only handling the local TFTP proxy. That message doesn't indicate anything to do with which wan is preferred or default.
