[Solved]If Wan cable is disconnected and connected, pfSense needs to be rebooted

  • Hi,

    I have a problem with my pfSense 2.3.2, Pentium Dual Core.
    If I disconnect my Wan cable and put it back in, I don't get a stable link.
    I get my IP adress for a second (Interfaces on my Dashboard). Then it goes red - then green with - then I get my IP adress. In a second it starts all over again with this behavior. It never stops.

    My gateway status say Online/Offline all the time.

    If I reboot pfSense the link comes up stable and shows Online the whole time.

    What can cause this?

    I tried to disable Gateway Monitoring, but still the same.
    If I try with another router it works ok, so it is something with pfSense

    Turned out to be hardwarefailure on ethernet card. Replaced at tested ok

Log in to reply