Trouble with Netgate SG-4860
-
I bought two of the Netgate SG-4860 models recently.
The first one is already doing it's job, VERY WELL.But the second one give me some trouble. It seems to reboot forever.
I wonder if I'll have to reinstall from a usb-stick.
Anyone has an opinion on this?here is a dump from the console
SMP: AP CPU #1 Launched!
SMP: AP CPU #3 Launched!
SMP: AP CPU #2 Launched!
Timecounter "TSC-low" frequency 1200029832 Hz quality 1000
Trying to mount root from ufs:/dev/ufsid/58a1f38af65348d4 [rw]…
WARNING: / was not properly dismounted
WARNING: /: TRIM flag on fs but disk does not support TRIM
Configuring crash dumps...
Using /dev/label/swap0 for dump device.
** SU+J Recovering /dev/ufsid/58a1f38af65348d4
** Reading 33554432 byte journal from inode 4.
** Building recovery table.
** Resolving unreferenced inode list.
** Processing journal entries.
** 5 journal records in 512 bytes for 31.25% utilization
** Freed 0 inodes (0 dirs) 0 blocks, and 0 frags.***** FILE SYSTEM MARKED CLEAN *****
Filesystems are clean, continuing...
Mounting filesystems...___
/ f
/ p _/ Sense
_/
__/Welcome to pfSense 2.3.2-RELEASE (Patch 1) on the 'pfSense' platform...
savecore: reboot after panic: ufs_dirbad: /: bad dir ino 321024 at offset 512: m angled entry
cpuid = 2
KDB: enter: panic
[ thread pid 21 tid 100107 ]
Stopped at kdb_enter+0x3e: movq $0,kdb_why
db:0:kdb.enter.default> textdump set
textdump set
db:0:kdb.enter.default> capture on
db:0:kdb.enter.default> run lockinfo
db:1:lockinfo> show locks
No such command -
That type of panic is due to a filesystem issue. You can either boot to single user mode and run "fsck -y /" a few times and then reboot, or you can reinstall from a USB memstick with a pfSense ADI installer image.
If you need help with either of those tasks, drop a line to our support team and they can get you more specific instructions.
