No LAN Interface under traffic shaper on 2.4?


  • As stated my LAN interface does not show up under "Firewall / Traffic Shaper / By Interface"

    My LAN interface shows up everywhere else, why not here?


  • @belt9:

    As stated my LAN interface does not show up under "Firewall / Traffic Shaper / By Interface"

    My LAN interface shows up everywhere else, why not here?

    Does ALTQ support your NIC driver?


  • I think I figured it out. LACP is not supported, the NICs are i340 so that shouldn't be the problem.


  • If you create a VLAN with the LAG/LACP interface as the parent it will then show up, at least it does for me.
    Good luck getting it to work properly though.  Im on 2.4 and when I enable the shaper using the wizard, the whole system just crashes after a couple minutes of shaping traffic.


  • I do have VLAN's running over the LACP and they do show up, just not the non-VLAN.

    There are some packages on pfSense 2.4.0 that do not work with traffic shaping. I forget what they are?

    I just ended up using dummynet and fq_codel which is LACP agnostic and it is working well!