Single to dual WAN IPSec - possible???
-
Should the following configuration work:
Cisco ASA (IPSec conf: Originate only; Remote Peer A and Peer B)(T1, one IP)
|
|
|
| WAN2 (IPSec PeerA)(DSL)
|
|
WAN1 (IPSec PeerB)(Cable)PFsense configured for failover only (no load balancing)
Yes or no answer will help, but any comments and hints will be apreciated.
thanks!
-
Two tunnels between the 2 devices only works if they connect different subnets on each device, since you want to use load balancing I assume this is not the case.
You can find more about this in the IPSEC and Mutiple Wan sections of this forum.Regards,