CE image install on SG-1000

rb_telit

I bought a SG-1000, it comes with the release version of 2.4.2 installed on it.
I am trying to reinstall with the CE development version but it will not boot from the mem stick nor a microSD card:
I tried to image the mem stick adn SD card from Mac OS using DD and from windows using Rufus, neither work.
It it wont boot from usb or SD, it boots from on-board mmc.
I did notice that on the release recovery image it creates a FAT partition that the CE editions do not have.

Any help would be appreciated.
Thanks!

Below is console output of trying to boot from CE image on usb stick:

U-Boot SPL 2016.03 (Dec 28 2016 - 14:33:36)
Trying to boot from MMC
Card did not respond to voltage select!
*** Warning - MMC init failed, using default environment

reading u-boot.img
reading u-boot.img

U-Boot 2016.03 (Dec 28 2016 - 14:33:36 +0000)

Watchdog enabled
I2C: ready
DRAM: 512 MiB
MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1
Card did not respond to voltage select!
** Bad device mmc 0 **
Using default environment

Net: <ethaddr>not set. Validating first E-fuse MAC
cpsw, usb_ether
starting USB…
USB0: scanning bus 0 for devices... 1 USB Device(s) found
scanning usb for storage devices... 1 Storage Device(s) found
Card did not respond to voltage select!
** Bad device mmc 0 **
Hit any key to stop autoboot: 0
Booting from: mmc 1 ubldr.bin
reading ubldr.bin</ethaddr>

ivor

You cannot use CE image for SG-1000, it's for x86-64 architecture. Download the SG-1000 ARM based image from portal.pfsense.org. If access to your portal expired after first year, it will be renewed automatically. Let me know if that's not the case.

https://www.netgate.com/docs/pfsense/sg-1000/reinstall-pfsense.html