PCI-E to Serial RS232 Add-in card not recognized
I was wondering if anyone is using a pci-e to serial RS232 add-in card for use with Services/NTP/Serial GPS and have been able to make it work?
I have installed the card, the BIOS recognizes it, but pfSense doesn't recognize it, as in it's not coming up as a serial interface choice when going to services/NTP/Serial GPS, as it does on my other hardware which has an integrated serial port on the MB.
Thanks in advance.
Does /var/log/dmesg.boot contain anything about seeing the card? If it's something like a 16550 UART it should just work. What kind of serial card is it?
Thanks Derelict for you help.
All I could see in the log that I think is relevent is this:-
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pcib0: _OSC returned error 0x10
pci0: <ACPI PCI bus> on pcib0
pcib1: <ACPI PCI-PCI bridge> irq 16 at device 1.0 on pci0
pci1: <ACPI PCI bus> on pcib1
pci1: <simple comms, UART> at device 0.0 (no driver attached)
vgapci0: <VGA-compatible display> port 0x5000-0x503f mem 0xa0000000-0xa0ffffff,0x90000000-0x9fffffff irq 16 at device 2.0 on pci0
vgapci0: Boot video device
xhci0: <XHCI (generic) USB 3.0 controller> mem 0xa1320000-0xa132ffff irq 16 at device 20.0 on pci0
xhci0: 32 bytes context size, 64-bit DMA
usbus0: waiting for BIOS to give up control
usbus0 on xhci0
usbus0: 5.0Gbps Super Speed USB v3.0
pci0: <memory, RAM> at device 20.2 (no driver attached)
pci0: <network> at device 20.3 (no driver attached)
pci0: <simple comms> at device 22.0 (no driver attached)
It's a SSU PCI-Express card with two serial ports available here:
That looks like it requires a special driver. I don't see that anything from SSU or the CH382L chipset is supported by the FreeBSD
You probably want to try something listed here:
Some of those are listed as specific cards, some as chipsets.
I'd probably try something like this:
That uses the Oxford 952 chipset though that particular card is not listed. The 952 is listed several times.
It looks like the
uartdrivers are compiled into the default kernel, but I have never had the occasion to use them.
I didn't know adding a simple serial port had gotten so difficult.
Thanks again Derelict for your valuable insights
I did see the Startech cards when I was searching for a good fit, and I am now ruing that I didn't order one. It looks like I have done my dough $$$ on the card I now have...
Your are absolutely correct - I didn't think it would be so hard to get things working.
This was supposed to be my cheap and economical to run setup.
I have a second machine with a Core i5 2500 (95W) that just chews the gas, but the MB has all the goodies integrated...
Looks like it's back to the drawing board lol