tunnel over slash 48

  • I have an he.net tunnel broker setup and working with their assigned /64.

    However, I also have a /48 assigned on the same tunnel. Unfortunately, i cannot get any traffic to route over that /48 tunnel. Tunneling from an IP on the /64 source works fine.

    What needs to change on my config to get pfSense to route the /48 network over the same tunnel?

  • Banned

    The /48 should be routed the same as the /64. Just assign a /64 block from your /48 to an interface and it should work for clients connected to that interface.

    Also make sure the he.net tunnel gateway is set as the default gateway for IPv6.

  • Thanks for the sanity check.

    I got a few IPv6 digits reversed. Fixing the typo fixed the routing. :)

Log in to reply