Wan Graph problem
-
Hello !
I have installed pfSense on my Alix board few months ago. I have upgraded to version 1.2.2. I have still have the same problem with WAN RRD Graph.
I have set up 2 interfaces:
- vr0 as LAN interface
- vr1 as WAN interface
- vr2 as DMZ interface
WAN Interface is declared as PPPoE.
With this basic configuration, Wan RRD Graphs are working perfectly.WAN Interface is connected on my ADSL Router using crossover cable.
The ADSL modem can be seen using the default IP 192.168.1.254.So I have set up these following things:
- route 192.168.1.0/24 to WAN Interface
- Declare a new Interface OPT2
I have edited config.xml file to set up a new interface OPT2 using <if>vr1 …
I have set up an IP address on that interface.Internet access is working fine, ADSL modem is seen on the LAN.
All WAN RRD Graph are empty now. If I want to see RRD Graph traffic on WAN (for example), I have to choose OPT2 interface.
No way to do something like this for Quality.Do you know if there is something to do in config.xml file to change configuration of RRD Graphs for WAN ?
Thanks in advance for your help.</if>