Traffic Shaping Rule not being triggered



  • pfSense Version 2.3.5-RELEASE-p2 (amd64)

    I have created a traffic shaper limiter that limits bandwidth to 15MBps, and associated it to a rule.
    My rule is in an IPsec interface and matches traffic between 10.208.235.128 and 10.208.29.21
    Logging is turned on and the limiter is selected under In/Out.

    However, my rule catches no packets, as seen in logging.

    rule order.jpg

    There are only two rules, so I am at a loss as to why no packets from 10.208.235.128/25 to 10.208.29.21 are captured by my rule and connections fall to the blanket allow rule below.

    Any ideas?
    Thanks in advance,

    John N.


  • Netgate Administrator

    Could be a number of reasons.
    The firewall states are already open. Did you clear any matching states.
    The subnets are wrong.
    The traffic is initiated in the other direction.
    There is no matching traffic.

    Also is there any reason you're on 2.3.5 when you have 64bit hardware?

    Steve


Log in to reply