Upgrade to 2.4.5 > 2.4.4-p3 SG-3100 ipv6 bogon list issue
-
@ngnym said in Upgrade to 2.4.5 > 2.4.4-p3 SG-3100 ipv6 bogon list issue:
Do I need to reboot again now (to make it use 400,000 vs 200,00) or is it still using 500,000?
On 2.4.5 there are two separate issues here. The pf table limit can be set immediately and it will use whatever value you put in there after the next filter reload. There is also a pf request limit which must be set and that only takes effect at boot time.
Presumably listing the wrong default is a bug, where should I report it
It's reporting the size as it was when the page was loaded, apparently, and not what the calculated default for the system would be. That may be a bug, though it should probably report both.
-
@jimp said in Upgrade to 2.4.5 > 2.4.4-p3 SG-3100 ipv6 bogon list issue:
It's reporting the size as it was when the page was loaded, apparently, and not what the calculated default for the system would be. That may be a bug, though it should probably report both.
Well, it technically does report both in that it appropriately shows the value that was set when the page was loaded in the field where you can change the value. The bug would be that the display for the "default value" stated under the field is actually showing the currently set value.
