Multiple IPSec using IKE v1 and v2?
-
I have an established IKEv1, cannot change that as the peer doesn't yet support IKEv2. I am trying to configure another IPSec tunnel using IKEv2.
It isn't working, is this even possible to do?
Is there anything I should specifically configure to enable the configuration?
I cannot find any guidance specific to mixing V1 and V2.
Thanks!
-
As long as it isn't going to the same remote address you can mix them. You just can't have two tunnels up (of any kind) to an identical destination.
-
Thanks, that's what I thought. Both have distinct peers.
They are reporting they are receiving IKEv1 packets but the config is most definitely set for IKEv2.
