how to configure PFSense with Static IP's BGW210
-
I currently use PF as my main router along with a BGW210 running in IP pass-through mode. I've had this config for 3 years with zero problems we even run IPSEC tunnels. I just purchased a /29 static IP block from ATT. So far on the BGW210 I've disabled IP passthrough as well as configured a pubic DHCP pool with my private address range I've also added the gateway address. I then configured a gateway on PF pointed to the same IP address that I used as the gateway IP on the BGW210 still nothing works. So if anyone's done this before please share your config.
-
I used to have AT&T static IPs on an NVG589, which is very similar to the BGW210. See if this info helps:
https://www.spearfoot.net/uverse-static-ip/
-
I actually found your tutorial posted on ATT forums I followed it still nothing works. I've contacted ATT they are suppose to send out a tech early this afternoon. Hopefully the tech will know who to contact in order to correct this.
-
@watts3000 Yikes! Well, good luck.
-
@watts3000 - I set this up recently and now trying to remember the steps. I believe I had IP Passthrough still enabled but but set to manual. Then entered static IP and gateway on pfSense side and was able to connect.
