pfsense routing issue
-
I'm trying to setup a IPSec tunnel with an outside company and seems to have hit a wall. In this case we have a single P1 with two P2 rules added to send two IPs over the tunnel and as it stands now they can ping me and get replied from both IPs however when trying to ping them the pfsense appliance is not sending the traffic across the tunnel but instead straight out the WAN.
I noticed that looking at the routing table there is nothing referencing the IPSec tunnel, is this normal? I know the path is good since they are able to ping me and get replies and I can see the traffic counters on the tunnel climbing however again pinging their IP I don't see that reflected in the counters on my end and they confirmed no traffic is hitting their end of the connection.
I currently have an allow IP ANY/ANY configuration in place on for IPSec which didn't make any difference, is there anyone that can shed some light?
-
Bump!
-
Is there a better section of the forum for this question?
-
Issue has been resolved, it ended up being a bug within Ubiquity firmware causing weird routing issues with /31 routes (Single addresses)