Netgate SG-3100 running 2.4.4 - 2 WAN and 2 LAN network - WTFBBQ - policy routing not working

[monocleitsolutions]

Hello,

Ok so I'm setting up a multi-wan configuration on a Netgate SG-3100.

LAN 1 is to use WAN 1 and LAN 2 is to use WAN 2, and neither LAN net should be able to reach the other's LAN network.

Both WAN links are ADSL: PPPoE for WAN1 is done on the Netgate, and PPPoE for WAN2 is done on the attached modem.

All 4 switched ports are configured with their own respective vlans to allow them to function as discrete lan ports.

Policy Routing catch all rules are configured for both LAN1 and LAN2 to point to their respective gateways.

Also a kill all traffic rule if their particular gateways go down.

When I set the default gateway to either WAN1 or WAN2 then both LAN1 or LAN2 will route out of that gateway only and ignore the policy routing.

Any suggestions are welcome!

Images attached

[monocleitsolutions]

@monocleitsolutions

FYI - Just to be clear Policy routing has yet to actually work at all.