New SG-2100 Doesn't Boot Out of the Box with Solution
-
It could just be me but bought a new SG-2100 with MMC for my in-laws and it doesn't boot up. Console shows it attempted to boot USB only and was confirmed by printenv.
Marvell>> printenv bootcmd=run setLED;run usbboot
Ran the following commands to get it to use MMC.
Marvell>> setenv bootcmd='run setLED;run mmcboot;run usbboot' Marvell>> saveenv Marvell>> reset
This did the trick and it boots fine without help. Hopefully this post helps anyone else that runs into this problem.
Packing slip says EM assembled and tested. I'm not sure that happened.
-
You should open a ticket with us about that: https://go.netgate.com/
There may be other envs missing or changed if that one was.
Steve