pfSense system display time
-
Recently I was checking DHCP Leases to see what time a device on my network had most recently connected and was confused until I realized that the times were being displayed as UTC. Is there any way to have set the system to display times as local? I have the correct time zone set and NTP has the local time. I just can't find a setting to get the system to use it.
Box: SG-4200
-
Services | DHCP Server | Time format change
About 3/4 of the way down the page. -
Perfect. Thanks.
-
@wgstarks said in pfSense system display time:
Recently I was checking DHCP Leases to see what time a device on my network had most recently connected ....
I wonder where exactly do you see time format for leases ?
-
@chudak said in pfSense system display time:
@wgstarks said in pfSense system display time:
Recently I was checking DHCP Leases to see what time a device on my network had most recently connected ....
I wonder where exactly do you see time format for leases ?
-
I did see this, but was asking about actually timestamp for leases ...
Looked here in Status /DHCP Leases and saw none, so was curios
-
Status>DHCP Leases
-
Not sure why you aren’t seeing them. The help section shows that start and stop times are displayed for all devices with DHCP leases.
-
@wgstarks said in pfSense system display time:
Not sure why you aren’t seeing them. The help section shows that start and stop times are displayed for all devices with DHCP leases.
Could you pls show your screen ?
-
@chudak said in pfSense system display time:
@wgstarks said in pfSense system display time:
Not sure why you aren’t seeing them. The help section shows that start and stop times are displayed for all devices with DHCP leases.
Could you pls show your screen ?
-
Thx I’m good, was confused by n/a for off-line leases
