MultiWan Load Ballancing faild
-
Hello Comunity,
Im not new here but yes i created this id recently. This is really a great community and i realy love being a part of it.
Im facing some issues with my dual wan load ballancing setup in pfsense 2.5.1 and hoping someone can help me with this issue. I been through most of the older topic, watched youtube videos but this seems to be not fixing my problem.
Ok, here is the config.
1--->> PPoE --> PFSENSE WAN PORT 1
2 -->> PPoE --> PFSENSE WAN PORT 2
3 ---> PFSENSE --> Gigabit LanI went to System -> Routing -> Gateway Group and clubed two wan together.
Trigger Level - > Member DownNow went back to Routing and made the defaullt gateway to Load Ballancing(created in the above step). I prefer to do it from the routing becuase in LAN rules i have multiple rules and dont wanna open each of them to change the gateway.(is this the best idea ?)
next went to System - > Advance and enabled the sticky connections.
then reload filters.After doing all of it my internert spikes on the second wan as well as in the first wan but after a while it only works with the first wan and second wan stays dorment, very small spikes where as in the first wan i might be pushing about 30-40Mbits per second,.
Also tried to change the firewall operating to agressive but ddidnt helped much.
Both the internet are from the same ISP and have diffrent gateway and have diffrent Monitoring Ip addres yet cant figure it out what is going on..
Thanks in advance, love the community, Love from INDIA.
-
Are you getting packet loss on the gateway connections? What happens with sticky connections disabled? The reason I ask is that I also have failover problems. Mine however is with OpenVPN gateways.
-
@townsenk64 Yes sometime i get packet loss, but most of the time its stable and loss is 0%..
