SG-2100 Upgrade failure from 21.05 to 21.05.1
-
Hello,
I have an issue upgrading my SG2100 from 21.05 to 21.05.1.
The upgrade fails and, after checking the dashboard, I see that my system seems to be full.
I tried to clear the logfiles but it doesn't help either.
Even after rebooting the firewall and disconnecting the power cable.
What can I do to fix this please ?thanks
-
Which part of the filesystem? How does it actually show?
It's almost always packages that cause a full filesystem, which do you have installed?
You can always backup your config and install 21.05.1 clean to get around this.
Steve
-
Use
du -h -d1 /to check from the console/SSH where your space is going.-Rico
-
@stephenw10
Hello Stephen,
Sorry for the late reaction.
Apparently it was the only package that I installed that was causing the problem : Surricata.
I already detected some issued in /var directory due to Surricata logs.
I have been forced to deinstall the Surricata package.
For so far I can see, it was the installation of 21.05 upgrade that causes most of Surricata configuration parameters to be removed.I will now re-install Surricata and I hope that I will not have the same issue with the future upgrades.
Thanks for your help
Philippe
-
It was the Surricata package that was causing the issue.
I have been forced to de-install it to get rid of it.thanks for your help
PHilippe
-
Suricata should run fine on the SG-2100. Just be sure to set log file size limits including a total size limit.
Steve
