Design help for better control

[moosport]

@johnpoz
No multiple hosts. Just one host.
No vlan traffic is captured in vswitch. Only default vlan traffic is in the trace.

[johnpoz]

@moosport well where did you come up with you need vdswitch then?

[johnpoz]

@moosport said in Design help for better control:

No vlan traffic is captured in vswitch

That has zero to do with vdswitch..

[moosport]

@johnpoz root cause analysis was suggested in a different forum.

Wire shark did capture vlan traffic on port going to ESX host. But pktcap-uw did not capture any on vmnic. Promiscuous mode was enabled too.

Switch configuration is correct.

Only data point which I still could not figure out is wireshark trace contains icmpv6 but not icmp dhcp discovery.

Neither ipv6 is enable on pfsense or unifi.