How do I specify LAN IP to specific WAN and other port traffic to specific WAN
-
I noticed that someone already posted this question back in 2012, and tried to setup, reviewed the post which was exactly as I had determined, but for some reason, the "LAN" rule of using WAN2 for a specific IP address is being ignored and sent using the WAN1 interface. I even put a firewall block on all other traffic after the WAN2, but the ip still connects via WAN1.
Under Firewall / Rules / LAN - Source-192.168.0.50 Port-* Destination-* Port-* Gateway-WAN2
any help is appreciated
-
@kruglerd
Consider that a new policy routing rule will not affect already existing connections.
So you probably have to kill the states for the rule to take affect. -
@viragomann I've rebooted the firewall in an attempt to ensure a "reconnection" and it still goes through the main WAN
-
@kruglerd
Ensure that the rule is applied to the meant traffic. Consider that the rules are probed from the top to the bottom. The first one which matches is applied and further rules are ignored.
Also consider that floating rules with Quick option and rules on interface groups are processed first. -
@viragomann 
image url)Nothing is listed in between the first lan address and the 3cx_PBX ip. If the first is applied and then ignored, I'd think the traffic should go through the WAN2 (wang as listed), but still shows as traffic is coming from Wan1 (Default)
-
@kruglerd
So WANGW is your WAN2 gateway?If pfSense allows access to go out there must a rule be responsible. So to check out which rule is passing the traffic out, enable logging in all your rules coming in considerations (don't forget interface group and floating), initiate a traffic and check the firewall log.