pfSense Plus version 22.01 and pfSense CE version 2.6.0 Software are Now Available!
-
Looks like it just doesn't like
0. If you enter a non-zero value such as1or30it takes it. But if you enter0then on save it changes to*. -
I created a Redmine issue to have the issue corrected:
https://redmine.pfsense.org/issues/13307 -
not sure this is coincident with the new release but after a ISP outage I found that dhcp service stopped handing out default gateway assignments. I had to go to each one and give the default default gateway value even though it wasn't required before.
-
@nrf said in pfSense Plus version 22.01 and pfSense CE version 2.6.0 Software are Now Available!:
not sure this is coincident with the new release but after a ISP outage I found that dhcp service stopped handing out default gateway assignments. I had to go to each one and give the default default gateway value even though it wasn't required before.
That is unrelated. That can happen if your upstream/WAN doesn't provide you with a gateway via DHCP. Some have also seen it if DHCP starts while a WAN is down. We're looking into ways to improve that behavior.
-
@jimp quick response!
ok, started while wan was down would explain.
but 192.168.xx.1 can be a perfectly good default gateway ip whether there is a wan or not so kind of curious behavior. now that I have populated the default default I won't be bothered by it again but it cost me in down time after ISP was restored. it makes the advertised behavior on that page no longer a certainty, maybe add 'might' or 'should' there?
-
This post is deleted! -
R rcoleman-netgate unpinned this topic on
