To 2.6.0 and => 22.01 or not ? that is the question :)
-
@steveits Apparently not...
-
@cool_corona The quoted picture is from 2.6/22.01. :)
-
Here is mine... widget ppfSense+
-
-
Exactly, the separate disks widget and the zfs widget are new in 22.01/2.6.
-
I tried to go from 21.05.1 to 22.01 on my SG-2440. It did not survive the reboot. When I power up, there is no console, and only a sold red status light until it self-powers down after a bit. Could have been a coincidental hardware failure, but figured I'd see if it happens to any one else. Was on the latest bios (17). Support told me it's likely a system board failure. Hope others have better luck! Spun up an old power hungry P4 desktop till I figure out a replacement :/
-
Here is mine. Widget pfSense 2.6.0
-
Got some bravery drink today and updated to zfs !!!
The process overall was not too difficult.
Most of the time and effort was spent connecting my pfS box to a monitor and keyboard as it runs headless all the time.And then figuring out how to change the boot order etc.
After restoring config.xml I went to the gym after I came back all packages were installed, except Avahi (!) - why? no clue. Installed it too.
Then updating to 22.01 was uneventful.
So now I see:
RAM is up very little.
Do I need to do anything about the zfs settings? Any cool zfs features?
Thx
-
@chudak said in To 2.6.0 and => 22.01 or not ? that is the question :):
Do I need to do anything about the zfs settings?
No, it's pretty much read-only. For this release at least.
Steve
-
Just upgraded, biggest disappointment is the 10Gb SFP+ ports still show a speed of "Unknown <rxpause,txpause>" on a 7100.
Or stated another way... It went smoothly with no real issues. This was a USB reload to get the current ZFS layout.
-
Using DAC cables? That's unlikely to change. It's a hardware limitation.
Steve
-
@stephenw10 1 DAC cable and 1 SFP+ Not the end of my world, just a nice to have...
