PureNAT / NAT + Proxy - Am i doing it right?
-
I have two WAN connections with two WAN groups configured in opposite failover. i.e. WAN1 - Tier 1 / WAN2 - Tier 2 and WAN2 - Tier 1 / WAN1 - Tier 2
To create an quasi balance, i direct some vlans to grp1 and others to grp2.
In any event, so long as there is one wan, all services should work.
I do the same thing with a VPN setup on top.I use the NAT + Proxy, as i understood I can't use PureNAT with the above setup as the WAN may not be up with the filters load, and the filters change if there is a failover.
i see a lot of xinetd readjusting service messages.
Just wanted to check, i am using the correct NAT type.
-
@gwaitsi is it working?
-
@phatsta strange.
-
i tried global settings to disabled, but system was good.
- maybe because i have redirects for dns, ntp
-
i set global settings to PureNat and rule redirect settings to Disabled
-
Port Forward settings to NAT+Proxy
seems to be working.
-
-
@gwaitsi said in PureNAT / NAT + Proxy - Am i doing it right?:
seems to be working.
Then don't fix it ;)