Intenet is not accessible using PFsense
-
Okay , I will switch to hybrid mode and will give the result, but how I can add a rule to cover all the subnets , I think I have approximately 24 subnets, is it something like 0.0.0.0 0.0.0.0 next-hop-ip.
Note: I did not change anything in nat and I left it as default.
-
Moreover, how to check that pfsense is sending the back route to cisco switches , ospf is enabled on all devices including but how I can make pfsense redistribute routes via ospf, I remember I checked an option under the title redistribute in ospf setting and don't know if that was enough .
-
If they are all 10.x.x.x as shown in your diagram you can just use 10.0.0.0/8. That's probably a wider subnet than you need though. Better to specify the minimum subnet size to cover them.
Steve
-
Check OSPF status on the switches to see if pfSense is advertising a default route.
Or just try to connect out from a client and see if that traffic is passed in pfSense.
St5eve
-
Sorry , I was busy these days
I will do it
Thank you Steve
