504 Gateway error after update

stephenw10

Another possibility here is that the 22.01 kernel has loaded from another boot device.

Do you have an SSD in that 2100? Is it booting ZFS from the SSD?

jvamos

@stephenw10
No it’s just stock. I think it’s just emmc.
Is there a good way to check?

Josh

stephenw10

You can run zpool status to see what it booted from.

You can run geom disk list to see the drives in the system.

jvamos

@stephenw10

zpool status
KLD zfs.ko: depends on kernel - not available or version mismatch
internlize ZFS library

This is the output of the first command

Geom name: flash/spi0
Providers:
1. Name: flash/spi0
   Mediasize: 4194304 (4.0M)
   Sectorsize: 512
   Stripesize: 4096
   Stripeoffset: 0
   Mode: r0w0e0
   descr: w25q32
   ident: (null)
   rotationrate: unknown
   fwsectors: 0
   fwheads: 0

Geom name: mmcsd0
Providers:
1. Name: mmcsd0
   Mediasize: 7820083200 (7.3G)
   Sectorsize: 512
   Stripesize: 512
   Stripeoffset: 0
   Mode: r1w1e3
   descr: MMCHC DG4008 0.1 SN A603B710 MFG 12/2019 by 69 0x0000
   ident: A603B710
   rotationrate: 0
   fwsectors: 0
   fwheads: 0

Geom name: mmcsd0boot0
Providers:
1. Name: mmcsd0boot0
   Mediasize: 4194304 (4.0M)
   Sectorsize: 512
   Stripesize: 512
   Stripeoffset: 0
   Mode: r0w0e0
   descr: MMCHC DG4008 0.1 SN A603B710 MFG 12/2019 by 69 0x0000
   ident: A603B710
   rotationrate: 0
   fwsectors: 0
   fwheads: 0

Geom name: mmcsd0boot1
Providers:
1. Name: mmcsd0boot1
   Mediasize: 4194304 (4.0M)
   Sectorsize: 512
   Stripesize: 512
   Stripeoffset: 0
   Mode: r0w0e0
   descr: MMCHC DG4008 0.1 SN A603B710 MFG 12/2019 by 69 0x0000
   ident: A603B710
   rotationrate: 0
   fwsectors: 0
   fwheads: 0

It's just the stock option.

stephenw10

Hmm, running ufs then and only one drive. Not loading a kernel from the wrong device then.

You can always reinstall 22.05 clean and restore the config. That is usually the quickest way to recover. Open a ticket with us to hey the firmware image if you need it:
https://www.netgate.com/tac-support-request

Steve

jvamos

@stephenw10 thanks Stephen

jvamos

@stephenw10
Form submitted.

jvamos

@jvamos

Now that things are working again all I can think of as the problematic settings are pfblockerNG-devel with a lengthy set of lists or the Firewall Log widget GUI being set to 500 entries while default rule logs was not turned off.

stephenw10

Hmm, that shouldn't be an issue. Glad you're back and running though.