Triple WAN Configuration on Pfsense

pndkp

Dear all,

Hope you all doing well. Can we configure triple WAN connections on Pfsense?
we have multiple VLANs and we want to set different internet on VLANs.
I tried in rules using changing gateway but it only works on 2 internet connections. Pfsense doesn't use a third internet connection. I also tried using load balancing with 3 internet connections using tire 1 but it didn't. We are using 2.5.2

rcoleman-netgate

@pndkp

@pndkp said in Triple WAN Configuration on Pfsense:

Can we configure triple WAN connections on Pfsense?

Yes. Just tier the WANs on failover. You need to make a gateway group, though, first.
https://docs.netgate.com/pfsense/en/latest/multiwan/requirements.html

A Former User

Hope you all doing well. Can we configure triple
WAN connections on Pfsense?

Ok, what hardware is involved, CPU, RAM, Eth/SFP ports
will be nice to know for us first. Also your entire internet connection speed for each internet link will be nice to know for us. In normal it would be able to realize with pfSense in several ways, like you need and want to go
with without any problems.

we have multiple VLANs and we want to set different
internet on VLANs.
At first I would to know about how many VLANs are in the game here and then on top it will be nice to know, why
you want to split them all.

I tried in rules using changing gateway but it only
works on 2 internet connections.
In normal we are talking here about three different steps
to set up for your pfSense and network. It is not wise to
set up all cross and try out something here and there.

We are using 2.5.2
Why not on version 2.6? Realtek drivers? Or something else?

Updating the pfSense (backup and config backup) will be nice to do first.
Finding a solution for the problem.
a.)
Building a Gateway group and then the 3 TIERS
and then set up load balancing over them.

Session based routing
Service based routing
policy based routing

Are all available to use for you, and a fail over on top comes!

b.)
Building 3 Gateway Groups and each is sorted with one
TIER! The set up for VLANx to VLANy please use this
gateway 1 or 2 or 3

That said we need a little more input oin this from you.

pndkp

I am using a PC for pfsense with ethernet ports. I have all internet connections with 100 Mbps. About Realtek drivers, I don't know. I have built a gateway group of all connections with tier 1 using a trigger level of packet loss or high latency. I am using the gateway of WAN1 to VLANA and likewise WAN2 to VLANB & WAN3 to VLANC.

pndkp

@rcoleman-netgate Issue solved there was no rule in outbound NAT. Thank you all for the support.

pndkp

@dobby_ Issue solved there was no rule in outbound NAT Tab. Thank you all for the support.